Is there a way to select outbound CLI for a call?For example we have a customer who has the following set up;- Fax Machine- Shared Group for Sales- Shared Group for Accounts- DID / DDIs- OperatorWhen the fax machine makes a call they'd like it to com...
Thought I'd start a public feature wish list. I'll try and keep them within the scope of where the product is aimed :-)Route to particular trunk based on number patternI would like the ability to say that numbers which match a particular pattern alw...
Hi All,I'm a little late to the party ... The UC320 I have here is running 1.01.01(000). I noticed on one of the other threads that 1.01.06 is now around. Is there any reason I shouldn't upgrade straight to this one?Mark
Maybe an extra tick box on the outbound like selection setup? So that dialling 9+Number goes out normally but 8+Number goes out withholding CLI?Remember that many SIP Trunk providers may not support outbound cli suppression.Mark
In which case can I get you to throw that on the feature request list please? Without it the entire company must go out as the same phone number. This is the norm on a FXO setup, but not on a small office PRI/BRI/SIP PBX.Mark
Two SIP Providers possibly, one 'normal' one and maybe one for a specific location. For example if a customer is UK based but does a lot of US calls they may take a second SIP trunk from a US provider to get a better rate.Probably not widely done, bu...
If you could squeeze secured VPN into the UC320 that would be great. Would give a solution to the encrypted voice and possibly also enable the remote teleworker handset VPN feature like there is on the UC500?Mark