Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a network where we are using 2811 running CBAC to a Hosted Call Manager Network. The 2811 is located in a centralised Data Centre, which connects to remote sites via MPLS network. We have had power issues (20 second outage) at one of the rem...
We are running CBAC on a 2811 route with the following IOS c2800nm-adventerprisek9-mz.12-24.T2 This works fine and allows and blocks the traffic as designed. However if we reboot the router CBAC stops working, to get it working we remove a rule from ...
Hi,
Would this also be the same if the user logs in each day (Same Jabber Client) and their Citrix session is coming from a different Server farm (Load sharing). Or should this be tied to their profile.
Thanks
Chris
Thanks for your help. The Show ver goes into the output analyser and gives me an output re memory area tried to be accessed that is outside of memory range....The Crash is not accepted by the tool. The only supported file close to this is Show crashd...
Here is the configNote that once this is working it is fine, only breaks after a reboot. Manual removal of the rule in the ACL and putting back in makes it work again.Router#show runBuilding configuration...Current configuration : 1411 bytes!version ...
