I would advise following some of the initial steps @jdb1 suggested. We can confirm a NAT router in front of us by examining the Appliance status page and selecting the "uplink" tab. If the WAN reads a private IP, we are likely behind a NAT. Similarly...

Hello,When the user connects we assign them a MAC address that will start with "03" and then the rest of the MAC is generated from a hash of the username.

Hi MarkReb, I know this is an older post but I figured I'd offer my thoughts on the topic. The issues that have been observed on MR29+ with client balancing are because we updated to an active client balancing method that can be more aggressive and c...

The flex radio settings are going to be located under Wireless > Configure > Radios Settings > RF Profiles Tab > Select your RF profile > General settings. Note this is only going to be relevant if we have an MR57 or Cisco Catalyst Wireless 9166 AP.

Currently, as @alessandrodematos stated, API and creating an alert based on the API result would be the best solution for a low-power mode alert. There is no native dashboard email alert or AP alert status for low-power mode. I did take a moment to ...