Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi together,we have a bad condition with MR 29.6.1 → MR 30.5 on AP MR36 ....Let's try to describe:We have 100 AP's, MR33, 36, 55 ...In some classrooms we didn't have enough RJ-45 plug near the beamer/projector, so we had used network Splitter. (1)Th...
Hello,we are a school with about 80 Rooms and in every room is a wireless connection to the laser beamer. This connector is called "AirTame".Is there a easy way to switch off client balancing for only a specific device group?Since we switched to MR 2...
@Mark Elsen first response -Please confirm the make and model of the referenced "network splitter" in use?https://www.delock.de/produkt/65177/merkmale.htmlBetter than they won't give a try
@Nightstick - in my case the accesspoint got PoE power and than search very log for a mesh neighbors. After it establish a connection over mesh it "works", but without use of LAN Cabeling.It looks to help first manualy force the switch networkport t...
@Mark Elsen it's fully clear, it has impact -- we installed the splitters about 18 month ago and the Accesspoints connect since then only "100 Mbit full-duplex" and no longer Gigabit.As the issue is only on MR36, i thought it could have to do wi...
For me the "funny" Part was that only the newer MR36er AP has this issue, the MR33 can handle it.As a normal Cat Cable has 8 "pin", the Splitter devide it in 2x 4 Pin. So two device has a "4 pin" cable. And it looks that the MR36 with fresher firmwar...
