Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was running a packet capture on a MS220-8p's uplink port and discovered that the switches IP was constantly pinging the google dns server 8.8.8.8. I can see no reason for this. Any ideas?17:08:05.873574 IP 172.16.1.202 > 8.8.8.8: ICMP echo request,...
I have a very simple setup in my lab. It's one MX65 connected to one MS220-8P connected to one MR30H. I set up a Radius server and configured the MR30H to use it for network authentication. Works great. Today I wanted to set up Radius authentication ...
I am attempting to configure RADIUS authentication for the first time. The AP is a MR30H. I set up two SSID's. One for Shared Key and one for RADIUS (following the instructions here). I can authenticate using the Shared Key just fine, so I know the b...
Hi Felix,I would try emailing support if you can't reach them on the phone. 3600 pings in an hour works out to 1 per second. I just can't see how that is generating 70MB/Sec because a ping is only 64bytes.Again, I would grab a packet capture off of t...
Felix,Taking a closer look at the second picture, it seems like you got 4.21GB of ping traffic over a period of 1 hour (which works out to about 70MB/sec. Yeah, that is an issue. You are essentially seeing a ping flood. I assume that the device at 1...
Hi Felix,The first picture you posted shows one ping about every 2 seconds. That should have no effect on your network. I'm not sure what the second picture is showing because there is no elapsed time.-P
