Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have recently installed some CW9166 6ghz access points.Would like to enable WPA3 to enable 6ghz operation, however there is no option to enable WPA3 transition mode when you are using Enterprise 802.1x security on an SSID.We have some devices with ...
I have tried converting existing SSID's over to WPA3.Once i have done this devices with the Intel AC8265 chipset will no longer connect, and if you google this it appears that they dont support WPA3. Unfortunately there are multiple trolleys full of ...
Yeah, thats what i'd like from "Transition" mode! - WPA3 only just for 6ghz.If catalyst supports it is this a setting that is likely to sneak into an MR firmware very soon?
I do a lot of heat load stuff for new buildings and generally give them these numbers from the datasheet as 'max heat gain' values.In cases where I get further questions or this number ends up looking stupid (often we end up using a lot of UPOE mgig ...
