Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I´m trying to configure a voip direct call between my 2901 router with two FXS ports and a Linksys PAP2T ATA.My router config is:dial-peer voice 1 pots destination-pattern 36000[1-2] port 0/2/0!dial-peer voice 2 pots destination-pattern 36000[1-2]...
One of the problems were the Session protocol sipv2the other was the codec configuration.Now I´m able to make and receive calls both ways but there is a one-way audio problem. Only the phone connected to the router´s FXS receives audio.Any ideas?Than...
Hi Campbell,Thenks for the reply.I´ve updated the dial peer as you recommended but still no success.I keep getting the error:rt-csc-2901-01#csim start 360001csim: called number = 360001, loop count = 1 ping count = 0 csim: loop = 1, failed = 1csim: c...
