Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts,
I am struggling to wrap my head around how I need to configure my external switch or if I even need it anymore.
The switch needs to be replaced and I was hoping to just cut it out altogether. It basically performs one more step of rout...
I have a WLC 5508 running 7.4.121.0 where several sites have APs in FlexConnect mode.For those sites I also have interface groups (this is just an example, i have more than one group)Site 1 - Group 1 - vlan 110 (faculty) and vlan 112 (students)Site ...
I have a WLC 5508 in my datacenter, and 1142s configured with FlexConnect at a remote site.Two issues:Some APs 'die' from time to time where I cannot ping them anymore and they do not service any clients. I can reset them from the WLC after which the...
Yes I have done that, unfortunately that is not the soluation. Remember that clients will connect sucessfully. Then randomly they will disconnect and not be able to reconnect with the message gateway could not be found or invalid ip . One thing i jus...
The APs are in FlexConnect Mode. On the WLC I was running 7.2.111 but am now running 7.4.100 (I continue to have the same issues as before). port config at remote site for the 1142s isswitchport trunk encapsulation dot1qswitchport trunk native vlan 2...
