Dear All,I am trying to poll the 5 minute average CPU utilization of my Cisco Aironet 1252 (IOS version 12.4(25d)JA) using SNMP OID .1.3.6.1.4.1.9.2.1.58.0 Howvere for some reason I am not getting any response back from the aironet. Note I am able to...
Dear allI have two cisco airenet 1252 autonamous access point that are configured as point to point bridge. Now I want to confiure AES encryption or WPA2 using a pre-shared key however I do not see the option to do this . The only option I see under...
Hi,I have two Cisco Aironet 1252 that I want to configure as a point-2-point bridge. Now I want to know if this configuration supports the 802.11n protocol.Regards,Screech
Hi,I have 2 cisco Aironet 1252 setup as a point to point link using an external antenna (one radio is setup as the root bridge the other is setup as the non-root bridge). Now I see that the connection between the radios is established at a speed of 5...
George,I cannot find those setting using the web interface (GUI) (I check under security and encryption manager). Can you give the instructions based on the web interface.Regards,Screech
Scott,I found the following statemen in the release note of IOS 12.4 (25d) (http://www.cisco.com/en/US/docs/wireless/access_point/ios/release/notes/12_4_25d._JArn.html#wp291685)802.11n HT Rates Apply Only to No Encryption or WPA2/AES Encryption The ...
OK so that means then that as soon as I see the utilization reaching 27 Mbps you can conclude that the link is getting congested.I am asking because our network monitoring tool uses the configured bandwith on the router interface as the capacity of ...
That was a troubleshooting mistake from my site.Since the link is half duplex so you expect half of the 54 Mbps as the throughput what do you recommend to configure as the bandwindth on the router interface ( this is used for Qos and routing purpose...