Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have an ACS 5.2 server connected to an AD domain controller which has several trusted domains. (domain1, domain2, domain3) We currently have to specify which domain each user belongs to (ie, domain1\user) in order to connect. We would like to o...
I have my ASA setup to hand out DHCP addresses to my clients. I have it also set to reuse an address 5 minutes after it is released. Is it normal that the first addresses are not being resused? Does it cycle through the full range and then start o...
We are running acs se 4.01 and whenever i turn on the remote logging to our agent, the ACS itself becomes unusable until I turn logging off again. Any ideas?
We have 2 switches that are in a VRF routing environment. They have no global routes. We cannot use our SNMP tools to monitor them. Is there something we can do to allow this or do we have to create a management interface?
We are trying to setup a 2811 router to run IOS based IPS. We followed all the procedures but we can't seem to get the system to send any alerts via syslog. We have tried various port scanners with no luck. Are we missing something?
what type of NAC? if you want want clean access you will need a NAC appliance. if you are just doing CTA or identity based with MAC addresses, you just need the ACS servers.
