Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi - Is anyone aware of a method of monitoring the bandwidth utilisation on a dynamic interface on a WLC?I'd like to monitor the traffic on each dynamic interface to generate usage stats on centrally switched guest and employee SSID's.Thanks
HiI'll be upgrading a HA pair of 5508's from 7.4.110.0 to 7.6.130.0. The documentation suggests that I just need to upgrade the active and this code is copied to the standby. Then simply reboot. After this verify that the active is not the standby HA...
HiI have a stack of 2 x 3650 at the core and an access layer stack of 4 x 2960X.I was planning on linking these with 4 x 1GB copper connections. Any thoughts on how this should be cabled?I was thinking 1gb copper uplink from each of the 2960X stack m...
Hi I noticed this feature is disabled by default.http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_010000111.htmlAre there any issues in enabling it? Looks l...
Hi Just wondered if anyone had noticed this with an upgrade to 7.6.130.0 and configuring HA SSO.Out of 44 AP's we had 6 that took a long time to join (2 hours). These were 1240 and 1130's. (I only noticed after the code upgrade and HA config)I tried ...
Thanks - Based on all the feedback I'll probably use 2 gig links from the master (one to each of the 3650's) and then 2 from another switch in the 2960X stack (one to each of the 3650's) . I'll configure etherchannel with LACP active. The 2960X is ju...
