Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an MR42 that constantly shows high latency even after rebooting the AP and power cycling the port. Cable test shows no issues. Channel config is set to auto.But when I ping it, to the AP and from the AP to the internet, there's normal latency:...
Hi all!I've got a strange one, there's a client showing up on a connection from my MX100 to a MS350.It's showing up as a MacBook and it's traversing different VLANS and constantly changing IP addresses between what appears to be 4 different IPs.When ...
After some investigation, the mac book pro's MAC address is matching the MAC of our MX.So there's some bug that's causing the MX to be listed as traffic on the network that's traversing all the VLANs.Got a case with the Meraki guys to get it taken ca...
The 2.4Ghz is on channel 1 and, after checking, there is a lot of interference there.Thanks for all the ideas guys, Now I've got something to work with.~Autumn
Unfortunately, we can't disable 2.4Ghz at the moment, it's a club in a senior community and they do use legacy devices.Have you ever had any success manually setting the channels or does the auto channel usually do the job better?Thanks for your inpu...
Thanks!! I'll look into it further. The fact that it's all local traffic is a good hint, thank you.In your opinion, is it something I should be worried about?If it's all localized traffic, does that mean it's pulling data from the servers/security ca...
