hi all - below is my sanitized ASA 5510 config. got an IPv6 T1 from at&t and im unable to pass any traffic from my LAN clients out. any help appreciated. thx-:ASA Version 8.2(2) !enable password PoBmYYxuAzCciKRA encryptedpasswd 2KFQnbNIdI.2KYOU en...
hi all - have an IPv6 network that is connected to our IPv4 subnet w/ a 2611 router. am attempting to set up a simple static NAT-PT between and IPv6 host (fdf2:a:b:c:1:1:1:20) and an IPv4 host (10.6.196.12).NAT-PT between the nets so the IPv6 hosts ...
hi all - im trying to SSH/telnet to my ASA across my remote access VPN tunnel butcannot get this to work. what am i missing? remote access VPN subnet: 192.168.25.0LAN subnet: 192.168.1.0config is attached. thx-
I'm successfully connecting to the tunnel and can ping hosts remotely by IP but am unable to browse the internet from the VPN client. Also, host name resolution on remote end is not working .. can only connect via IP address. Ideas? Thanks again!
Not sure what the deal is but my remote access users are being prompted to login to the ASA before connecting to tunnel. How can I disable this? Attached is config. Thanks all-
don't think this is the problem at the moment. i dont have any win hosts hooked up. trying to access via ubuntu and a cisco 4500 switch behind the asa.
