Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I have been struggling for a few days with getting site-to-site traffic working across a L2L IPSec tunnel. At this point, I have the tunnel up, and I see packets being decrypted on the correct IPSec SA's when I ping from a local netwo...
Having the same problem on Windows 7, with the same models.Infrastructure:2 x Cisco Secure ACS serversCisco 4400 series WLC at each site, SSID is configured with WEP encryption, EAP-FASTLocal:Dell laptops (normally Latitude D620/D630s, but some newe...
Changing the routes on both sides finally solved everything!On the ASA:My previous routes wereroute outside 10.200.0.0 255.255.0.0 nn.nn.12.129 1route outside 10.240.4.0 255.255.252.0 nn.nn.12.129 1This had worked for our previous L2L connection from...
Manish and cciesec2011,The ip route statements on the router is currently:ip route 0.0.0.0 0.0.0.0 Serial0/0/0:1 ip nat inside source route-map NO_NAT interface Serial0/0/0:1 overloadThe result of "sh ip route" is:Gateway of last resort is 0.0.0.0 to...
Manish and cciesec2011,Thanks for sticking with me so far. I have tied the Loopback0 interface directly to the peer address for the IPSec tunnel. no ip nat inside source static 1.1.1.1 nn.nn.244.210interface Loopback0 ip address nn.nn.244.210 255.25...
