About RumorConsumer

RumorConsumer · 08-05-2023

Hey allI have a MX68 in an environment with a bunch of devices - average 130 clients a day. Half of these devices are LAN only ie NAS's, switches, IoT sensors, point to point bridge units. For those who know me, it's a retreat center. Recently, we've...

RumorConsumer · 06-08-2022

Hey allI have a Synology NAS on my network called beefcake (beefcake.local) that has a few network interfaces on my LAN that perform different jobs. I have a single gigabit port and a couple SFP+ ports for high speed transfers. I want my standard use...

RumorConsumer · 12-01-2021

Hello!I have an MX68 set up with multiple VLANs.I have the network hardware and APs on 1, the clients on 4, and a special VLAN 12 set up for me for a specific purpose.I have a Synology with 2 10gig LAN ports, both connected to a 10gig Mikrotik switch...

RumorConsumer · 08-21-2021

I have an MR52 close to my desk and I can hear a little electronic noise coming from inside. Its not super loud but its definitely present and it intensifies with network activity. Anybody know off top if this is all MR52s or if theres a gradient? I ...

RumorConsumer · 08-21-2021

Hello!I have a new Xfinity installation with an MX68. Using an Arris S33 cable modem. Im being rejected using Client VPN. My other install is on AT&T biz fiber and it has no issues. Im reading around and have seen the suggestion that Ill need to add ...

RumorConsumer · 04-19-2024

Update again 7 months later - flawless operation with the same firmware I downgraded to. Works perfectly not a single hitch. Totally a firmware thing. 16.16.9

RumorConsumer · 12-09-2023

Update - This continues to be rock solid stable. Meraki was out of their minds telling me the later firmware was ok and it was my fault for overloading the device. The rolled back firmware is chefs kiss perfect.

RumorConsumer · 10-04-2023

The two APs on the POE+ ports winked out again. Everything else seems normal. I decided to say screw it and put those APs on ports 5 and 6 on the MX68 with injectors. Just bypass the built in POE+ ports altogether. I had seen this before on the other...

RumorConsumer · 09-25-2023

So far the downgrade to 16.16.9 has been a dream. I had a bunch of people here on property and the MX didn't even sneeze which is whats supposed to happen. I got up to 245 clients.

RumorConsumer · 09-19-2023

Got a downgrade last week to 16.16.9 after the replacement unit suddenly decided to stop feeding data to the two POE+ ports. The rep said this was the last firmware he considered stable. Wow. So far so good.

Member Since	‎07-07-2019 05:58 PM
Date Last Visited	‎03-28-2026 01:21 AM
Posts	111
Total Helpful Votes Received	43

User Statistics

User Activity

Bringing down MX68 Utilization and AMP

How to get a specific hostname to route to a specific IP address

Traffic is routing from my 10gig switch back through the MX

MR52 Coil whine?

Client VPN over XFinity Cable

Re: Bringing down MX68 Utilization and AMP

Re: Bringing down MX68 Utilization and AMP

Re: Bringing down MX68 Utilization and AMP

Re: Bringing down MX68 Utilization and AMP

Re: Bringing down MX68 Utilization and AMP