Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have a few port redirects and it doesn't seem to log the flows on the Syslog server. The device has just been switched from Bridge mode to Routed mode and the logging doesn't seem to be as informative.In bridge mode it would log port forwards f...
Hi,I have enabled the Sign-on with Active Directory on our MX device for an SSID.How do you revoke this access for a device/user?Ive tried forgetting the device in the dashboard and setting the splash page renewal to 30 mins, but once the device has ...
Ive managed to fix the issue. It wasn't with the MX it was with the Syslog server. There was a setting to specify source and the MX's IP address had changed from when it was in bridge mode to now be our gateway device.Many frustrating hours later. It...
Yes the AP's are all in the same network and organisation as the MX. Same subnet, no fancy VLANs or routing. They are also literally plugged in to the MX, same as the Syslog server.I haven't been brave enough to put the "beta" firmwares on, I did not...
Hi,Thank you for your reply. Yes all the same port forwarding rules have been set up again (as it cleared those but kept the outgoing rules when I switched it over). I didn't notice but in your example where yours shows "MX1" ours only shows our WiFi...
