Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i am about to upgrade to this version and just wondering if anyone has seen an issue with this new version? i have more than 15 ASA's that i would wanna upgrade to this version. thank you,
i have the following applets. the applet test work but not the Force-InterfaceUP.
event manager applet test description Wan Disconnected event syslog id 602304 event syslog id 603109 action 1 cli command "en" action 2 cli command "config t" action ...
we have an issue here where when the dsl line goes down and when it comes back up, our asa couldn't re establish the tunnel. a ping of both peer wan ips are successful but not the inside ips/devices. we usually would reboot/reload the asa and then i...
is your outside interface route to wan gw?cli: sh run routeroute outside 0.0.0.0 0.0.0.0 123.456.123.678 (how mine looks)i get that issue you are having when i dont route the outside interface to the wan gateway.
you can try using the windows host file to direct non authorized internal workstations when they try to connect to the anyconnect ip to go to 127.0.0.0. if you want to monitor who is connected it from the asa side, i would create an eem script and h...
thanks again, Joe. it is working now. i had to put a watchdog timer in between the applets to allow time for next applet to execute orderly fashion. its been a week and applets are working how i want it to be.
thanks again.
herman
