Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have just started to learn about the 802.1x standard and I am trying to do some test before I deploy it in my corporate network. my question is if I configure the port with command access-session port-control force-unauthorized and dot1x sys...
Hello,
I have configured a port security feature on switch port Gi1/0/13 which allows only two mac addresses to be forwarded (See image_1). the switch port is connected to a wireless access point where clients can access to a local network.
based...
Hello everyone,
I work as network administrator in industry company and i am about to install our local network throughout the areas of the factory. i have designed my network with all the specification needed (see the attached file). i am going to ...
Hello everyone,
I have designed a network topology for my company, and my network will carry all type of traffic Data, voice and Video (IP camera). you will find an attached file that shows my topology. my topology has been designed in hierarchic...
Hello,
Based on the diagram attached that i have designed, i am experiencing very slow connection to the internet. i don't know why, i might be that something is wrong on this topology. could someone suggest what would be.
by the way the internet ...
Hello,
this get me a bit confused.
based on what you have said, here is what i have noticed :
1. the output shows that all the addresses are statically learnt not dynamically.
2. let's say that i have configured all the 10 MACs. suppose that one M...
Hello,
you can notice that i have allowed only two mac addresses, if you see to the CAM table, the interface allows more than two MACs to be learnt. why?
basically, it should allows only the two MACs addresses configured even if the maximum number ...
