Hi, You can use Netflow-9 for monitoring traffic of ASA Firewall 5512. ... View more

Let me know about the IP's you are using for VPNs, Loopback or real IPs? Use dynamic protocol for ip addressing, do not know use static IPs.     Jerry Paul www.thenetworkhardware.com ... View more

Remove QoS and check the results. Let me know about the effects.     Jerry Paul www.thenetworkhardware.com ... View more

This is an issue of DHCP. Re-configure DHCP and stable IP address.       Jerry Paul www.thenetworkhardware.com ... View more

Try using http://192.168.0.1   ; this will work       Jerry Paul www.thenetworkhardware.com ... View more

This is not fault of your switch. Divide users in VLANs. Configure QoS and set separate bandwidth for wvwery VLAN.     Jerry Paul www.thenetworkhardware.com   ... View more

download latest TFTP. Connect switch and router with straight cable. use following commands: copy tftp://TFTP_IP/IMAGE_NAME flash: boot system flash:IMAGE_NAME reload     Jerry Paul www.thenetworkhardware.com copy tftp://TFTP_IP/IMAGE_NAME flash: boot system flash:IMAGE_NAME reload - See more at: https://supportforums.cisco.com/discussion/12528166/install-os-new-switch#sthash.KSN6OrHW.dpuf copy tftp://TFTP_IP/IMAGE_NAME flash: boot system flash:IMAGE_NAME reload - See more at: https://supportforums.cisco.com/discussion/12528166/install-os-new-switch#sthash.KSN6OrHW.dpuf copy tftp://TFTP_IP/IMAGE_NAME flash: boot system flash:IMAGE_NAME reload - See more at: https://supportforums.cisco.com/discussion/12528166/install-os-new-switch#sthash.KSN6OrHW.dpuf ... View more

Hi, configure it for failover on all links. Load balancer is dividing speeds.       Jerry Paul www.thenetworkhardware.com ... View more

Hi, Yes it is possible to load multiple iOS depending upon the flash memory. use this command: copy startup flash     Jerry Paul www.thenetworkhardware.com ... View more

Hi,   First of factory rest your devices and then load it from TFTP.     Jerry Paul, www.thenetworkhardware.com ... View more

Hi,   Use F5-1600 for load balancing. This is the best solution for multiple ISPs.     Jerry Paul www.thenetworkhardware.com ... View more

Hi,   Connect the last port of 2960 switch i.e 0/24 or 0/48 or Gigabit Ethernet 0/0 or 0/1 port with the SG200 gigabit Ethernet port or last port of FE and make this connection as trunk. Those ports you want to isolate, keep them in separate VLANs.     Jerry Paul www.thenetworkhardware.com ... View more

Hi,   Use Putty 0.64. Install it and check.     Jerry Paul www.thenetworkhardware.com ... View more

Hi,   Downtime is different on different media types like server, direct cable, fast Ethernet or gigabit Ethernet. Approx downtime will be 25 to 30 minutes.     Jerry Paul www.thenetworkhardware.com ... View more

Hi,   Install driver for cable from cd on windows. Then go n check from device manager that either driver is installed or not. If it is installed properly then add that port to Puttie or Hyperterminal.     Jerry Paul www.thenetworkhardware.com ... View more