Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to allow vpn passthrough to my 2620xm routerI need to open some ports 500 4500 and protocol 50How do I do this by using ACL's?Is this possible?What about the Protocol 50?Please give me an exampleThank You
Hello..I have a 2620xm router with AT&T DSL 6000/768 service....When I setup pppoe using the WIC-1ADSL my speed is 2369Kbps... (DSL>>Router>>Lan)When I setup pppoe with a DSL modem infront of the router my speed is 5460Kbps.... (DSL Modem>>Router>>La...
I have a Cisco 2620xm router connected to DSL Modem (waiting for WIC-1ADSL card)......configured for DynDNS.DynDNS is configured with the following:mydomainname.netexchsvr.mydomainname.netftp.mydomainname.netftp1.mydomainname.netns1.mydomainname.nets...
I have a 2620xm router with interface 0/0 connected to RoadRunner cable modem, this is DHCP.I have interface 1/0 connected to the LAN with a fixed IP address, and I have (2) DNS servers running on the LAN.- When I load a web page I get "problem loadi...
ya....thanks....i was just hoping there was a way to have it in my config file all the time....
that "debug ip ddns update" command does not use any at all cpu power I just want to verify that the ddns update is working when i check my syslogs every ...
Well seeing how I got many suggestions and help.....I was persistent in solving the issue......so I dug deep into every bit of Cisco documentation I could find...The speed issue is resolved...- Using the WIC-1ADSL- No DSL modem in front of the router...
I am running an actual NTP SERVER PRODUCT on a Windows 2003 Server..it DOES NOT use the windows time service...and I have a Garmin GPS-25LP module/GPS receiver that the NTP SERVER PRODUCT sync's too....This Window 2003 Server is the MASTER NTP SERVE...
Hello,Yes I can ping 192.168.0.1Here are the NTP statements in my config file:ntp loggingntp server 192.168.0.1 source FastEthernet1/0 preferaccess-list 102 permit udp host 192.168.0.1 eq ntp host 192.168.0.50 eq ntp
