Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have ISE 2.2. My customer is looking for posture assessment by checking SCCM missing patches on windows 10 users machines.
Machines are getting not Complaint as i can see Anyconnect is not able to detect that SCCM is missing however SCC...
Dear All,
I deployed ACP on my FTD devices but still showing running since 1 day !. I don't know how to kill or delete it.
below is the message
Deployment - Policy and object collection complete. 23h 2m
40%
Any idea please?
Hello All,
I'm in trying to convert ASA configuration file to FTD but gettingbelow error on FMC virtual
Error
Invalid ASA configuration file! Please pass a valid file.
I'm following Cisco guide I installed FMC virtual on VMWare and trying to upload...
Dear Experts,
I'm installing 4110 for the first time.
My customer wants to have Anyconnect feature so decided to go with ASA on 4110. Application is installed but i dont know how i can enable IPS on it, is it same like legacy ASA with sourcefire s...
Hi All,
I want your help to know if Cisco 4500 supervisor engine II-Plus-10GE WS-X4013+10GE 10G supports any type of 10G line cards or we have to upgrade the supervisor engine.
Thank you in advance
Hi ortiz
As prashant mentioned, you need to use Lab virtual FMC. never use the production FMC for configuration conversion because once you use it for conversion you can revert it back and disable the conversion tool ( anyone correct if mistaken ple...
Hi Prashant,
So you used one security zone for each of interfaces on your existing ASA?
Yes
Can you please confirm if you have applied new ACLs under pre-filter or access control policy?
ACL is applied under ACP .
There is no security levels in...
Hi Prashant,
I didn't get any clear clarifications on zones vs interface groups so I ignored interfaces groups. i used only zones and removed all interfaces from interface groups. All my ACL and NAT are mapped to security zones only. Last Friday we ...
after importing configuration file to production FMC i don't understand interface groups. I used to assign one interface to a zone earlier. but interface group is new for me.
can anyone explain what is interface groups vs zone.
Thank you
I found the issue. the line highlighted in blue was missing !!!. I don't understand why the tool gives error with such line.
!
: Saved
:
: Serial Number: *********
: Hardware: ASA5585-SSP-20, 12288 MB RAM, CPU Xeon 5500 series 2133 MHz, 1 CPU (8 ...
