Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to do basic PBR, If from this network going to this network next hop 10.x.x.x.My challenge is I have a Cat4232L3 running 12.0. To the best of my knowledge Cisco does not Make 12.1 for this module and most PBR is on 12.1+.I have been unable to...
I have a serious problem with Pix 515. I have upgraded the system to6.3.1 and the PIX rebooted a few times before coming up. The PIX shows thefollowing error when it reboots:imgsum_config: sumval(0xa1b7) md5(0x95937073 0x75b817db 0x54d7811a 0xba7d021...
I have a 515E-RCisco recommendsPIX-515-MEM-32= [Covers: PIX-515/515E Restricted models for release 7.0+] PIX-515-MEM-128= [Covers: PIX-515/515E Failover and Unrestricted models for release 7.0+]If I am going to upgrade why not do 128MB?Before I make ...
The current solution that has been working.....I write erased config.Converted conduits to ACL'sUpgraded toCisco PIX Firewall Version 6.3(5)Cisco PIX Device Manager Version 3.0(4)Did not apply activation keyAll seems well so far.
Two more questions1) Do you want to perform Port Redirection or a static NAT with filteringYour config is for static NAT with filteringPort redirection might look more likestatic (inside,outside) tcp interface smtp 192.168.1.4 smtp netmask 255.255.25...
Three quick things off the top.1) Can you post the config2) Port mapping is done on the external interface and not the external gateway. so give that a shot.3) Try the gui. it often is forgiving and guides you through some configuration
