Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a (1) POD CCNP lab setup that I recently started up for some practice labs. (2) of my 2501 routers seem to have some kind of issue but I'm having trouble isolating. Below are the errors I'm seeing. Can anyone point me in the right direction? I...
I have (2) networks I'm dealing with in this situation. NetworkA has firewallA (pix 515e) with computerA behind it. NetworkB has firewallB (asa5510) with computerB behind it. I successfully use a software VPN client on computerA to connect to firewal...
i have a cisco 1720 at home that is sitting behind a dsl connection. my objective is learn as much as possible about the traffic that goes through it and how to control it with access-lists.the reason i'm posting this conversation is because i go to ...
I'm connecting to a pix 515e at work from home using the cisco vpn client(4.6.03.0021). At home, I was previously using a linksys router and was able to connect to the PIX just fine. The linksys died on me so I'm using a cisco 1720. Since I've starte...
Thanks CriscoSystems. I performed some tests last night and found I had one bad flash simm in each router. I added the (2) good ones to one of the routers and it works fine. Thanks for everyone's help!
Thanks Narayan.I'm going to try taking a flash stick from one of the other routers to see if it works in there. I didn't want to try that before because I didn't know if the board would damage it.
Thanks for responding whisperwind!This is the config I have for NAT though:global (outside) 10 interfacenat (inside) 10 0.0.0.0 0.0.0.0 0 0I thought that was pretty standard but should I try something else?If anyone has an article to recommend for th...
I should clarify that the cisco VPN client software on computerA successfully connects to firewallB, it just doesn't seem to pass traffic through it. Again, if I replace firewallA with a linksys, I can connect and pass traffic through the tunnel.
Rick,Do you recommend a different path for this situation? Those were the best ideas I could come up with what I currently know. I understand that a www request will come in on port 80 and leave on a different port so I couldn't think of a way to let...
