Hi, my I have an rv042 subnet 192.168.1.0 gateway 192.168.1.1 I also have a tg585v7 provided by my ISP. This has subnet 192.168.2.0 and gateway ip 192.168.2.1When I connect the tg585 to wan1 with the rv042 set to obtain ip automatically and dual wan ...
Hi,I have recently purchased the rv042, I have two broadband connections both PPPoA, the first has a static IP and connects with the rv042 no problem (via a Thompson 585v7 in bridge mode).The second has a dynamic IP. I have set the Thompson 585 '...
I have an RV042 setup for quick vpn access.The remote computer in question is a win 7 64bit. The PC uses McAfee SAAS firewall. This disables the windows firewall.1. I can connect to the vpn with SAAS disabled and windows firewall enabled.2. I cannot ...
Hi josejack,I have 1 ISP but 2 adsl connections and hence two modems with their own public ISP.I cannot clone wan1s mac to wan2 since the must both be different. I have tried cloning the mac of my pc and of my tg585 modem, but this makes no differenc...
Hi josejack,The rv042 and tg585's all have the latest firmware.both WAN ports use the same ISP.But I cannot even get a correctly work setup on WAN1 to work on WAN2
Hi Joisejack,Strangley no!even with the primary wan as wan 2 the ip is still shown as 0.0.0.0the only way to get an ip in there is to set it to be static.Which I dont mind.But this leads to a lot of dropped packets when in Load balance mode, and all ...
Hi Josejack,Thanks for the reply.I have tried powering down the modem and repowering whilst connected to the rv042.I still doesnt pull an IP but the system summary does show the port as connected.
