Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm connecting two building with Cisco 1300 bridge as secondary (backup link). My primary link is fiber.I manage to configure the root bridge and non root bridge successfully and the traffic is flowing. However only the Native vlan (127) is flowi...
Hi,I'm having 2911 routers with Cisco WAAS module installed. While configuring the WCCP on the 2911 router, I see additional interface tunnels gets automatically created once I issue ip wccp 61 and ip wccp 62. It gives these tunnel ip address from 17...
Hi, I have installed ACS 5.1 in one of our customer location, and I integrated with their AD successfully, authentication and authorization works perfectly.My question is for example if from AD I forced the user to change the password at next logon. ...
Hi, I have Windows ACS 3.2. It's integrated with windows Active Directory 2003. Frequently I'm getting the following error:"An error has occurred while processing the external database configuration page because of an internal error"To solve the prob...
Hi abukuru95, I'm having two building (Main Building and Remote Office Building). Each side I'm having 3560 switch. The topology is exactly as this:SW1 --> Root Bridge --> NON Bridge --> SW2Please find below the configuration for both Switches:Main O...
Hi Stephen, I tried what you suggested but did not work and tried the no negotiate as well. Actually I facing a new issue now. My setup is as following:SW1 --> Root Bridge --> NON Root Bridge -- SW2I cannot ping Root Bridge and NON Root Bridge from S...
well my friend thanks alot for your reply. My mistake, I was trying to use noncomplaint passwords, AD was rejecting those passwords. Afterwards I tried both SSH and TELNET both works well.
