About vincent.munier

vincent.munier · 08-22-2011

Hello,I'd like to create a site-to-site vpn between an SRP527 and an other vpn gateway. The problem is i don't see how to route all traffic from the local network (network defined by the lan ip interface of the SRP527) to the other vpn gateway? It se...

vincent.munier · 12-09-2010

Hi,I have 2 hosts (on 2 switches) that communicate wich each other. host 1 is in the vlan 1 and host 2 is in the vlan 301. The 2 switchs are not on the same vtp domain so the uplink between the 2 switchs in access mode.It's working whitout problems ...

vincent.munier · 12-09-2010

Hi,I've done the same:r3s04#sh cdpGlobal CDP information: Sending CDP packets every 60 seconds Sending a holdtime value of 180 seconds Sending CDPv2 advertisements is not enabledr3s04#But there's no change, i always have the mess...

vincent.munier · 12-09-2010

Hi,I've tried to disable v2 cdp advertissements, but it does not change. It would've been a good solution.Regards

vincent.munier · 12-09-2010

Thanks. It's a shame to have to disable cdp for that, but i'll do it because i can't easily migrate my vlan 1 in vlan 301.Vincent

vincent.munier · 12-09-2010

Yes of course, but i've used acces mode because my vlan 1 on switch 1 is not the same vlan than the vlan 1 on switch 2.Thanks.

Member Since	‎12-09-2010 06:06 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	6
Total Helpful Votes Received	5

User Statistics

User Activity

routing all traffic to a vpn site to site with SRP527W

Native VLAN mismatch error on access port

Re: Native VLAN mismatch error on access port

Re: Native VLAN mismatch error on access port

Re: Native VLAN mismatch error on access port

Re: Native VLAN mismatch error on access port