Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Fellows,I would like to know if there is any chance to have running in a cisco device SNMPv2 and SNMPv3 at the same time? I would like to know if both protocols could coexist?.I am in process of migrating from SNMPv2 to SNMPv3 and I would like ...
Dear Fellows,I have been experiencing some issue with a portchannel interface.I have two cisco switches 3560 and I have a portchannel between them ( It is composed by two gigabitethernet interfaces generating a portchannel of 2 Gigas ).Unfortunately,...
Dear Fellows,I have to drop some messages from the "show logging" command.Basically, I have to drop the events that contain the string "MAC_MOVE" or "NATIVE_VLAN_MISMATCH".I tried with the following command: (I called test to my discriminator)logging...
Dear Fellows,I believe that I should have started with this issue because I cannot run tclsh on a multilayer switch.When I try to execute "tclsh" command I receive this message:SWITCH#tclshTranslating "tclsh"...domain server (X.X.X.X)% Unknown comman...
Dear Fellows,Is there any chance to create a script to be execute every day at a schedule time?.I would like to run a script to execute the "debug ip dhcp packets" command every day just in case tha router reboots.Thanks in advanced.
So, as I understand. If I continue aggregating more interfaces, only one interface is going to flow data correctly. Is that correct?. The other ones are going to traffic only a 10%?
Thank Giuseppe!However, I would like to know if there is any chance to balance both links correctly. (450MB more o less on both gigabitethernet interfaces).Thanks in advanced!
Thank you ngoldwat!However, I need a logging discriminator that will drop any message that contains MAC_MOVE or NATIVE_VLAN_MISMATCH (I need to drop both events).Thanks for your help but I would like to know if logging discriminator could work with ...
You should execute the "show ip route" command command.To see static routes execute"show ip route static" command.To see rip routes execute "show ip route rip" commandTo see ospf routes execute "show ip route ospf" command.To see routing protocol exe...
