d.poppleton
Beginner
Beginner
Member since ‎05-15-2008
‎08-18-2021

User Statistics

  • 16 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

I have this configuration: event manager applet clear_nat_1event track 1 state any maxrun 40action 1.0 wait 35action 2.0 cli command "enable"action 3.0 cli command "clear ip nat trans *"action 4.0 syslog msg "WAN Failover, cleared NAT" I have the max...
I have this configuration: event manager applet clear_nat_1event track 1 state any maxrun 40action 1.0 wait 35action 2.0 cli command "enable"action 3.0 cli command "clear ip nat trans *"action 4.0 syslog msg "WAN Failover, cleared NAT" I have the max...
Has anybody done a 'spanned' lan over a layer 3 connection (PRI terminating on two routers) so that devices on both ends are on the same LAN? I think Cisco calls it IRB, and they have examples on one router, but my need would be to have it on two rou...
I just upgraded my 7206 from an NPE-400 to an NPE-G1. It is a WAN router connected to a core switch (6500). The connection between them (as a point to point routed link) was 100/full, and is now 1000/full over copper. The Gigabit interface on the rou...
Community Statistics
Member Since ‎05-15-2008 07:23 AM
Date Last Visited ‎08-18-2021 12:04 AM
Posts 16