Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I was wondering if anyone knows a way to have a welcome message on the MCU 8510 that can display the conference name when a participant enters the conference.We have TelePresence Conductor installed in our environment and when you dial into a ...
Hi All,Is there an accurate way to check for the number of Movi users that are signed in without having to log into the VCS Control/VCS Expressway?The problem is that TMS does not report the number of active users accurately, and as we are importing ...
Webex has supported our Hybrid Working scenario for over 5 years now and allows colleagues from all over the world to collaborate regardless of being in the office, remote or in any one of our video conference meeting rooms.Our usage has increased si...
We had issues from Cisco Jabber (via Call Manager 9.1.2). Since we limit the codecs to G.729, there was some limitation in the Acano 1.9.* code which only allowed a number of calls with this codec. After around 65 calls, any further calls would fail ...
We upgraded our production environment on the weekend just gone from R1.6.* to R1.9.2. We were going to upgrade to CMS 2.0.1 but held off due to CMS 2.0.1 being recently released.
We hit a number of issues, currently open with Support so i'd hold off...
Hi Shane,Under the settings (Settings, Conferences), there is an option for the MCU to "Enable resolutions above CIF to be sent to Cisco Unified CM". Is this enabled and does changing this make any difference? I know you mentioned receive video but w...
