Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
You can verify the PIX does not have the license required by using the show version command. If 3DES and AES is there, you don't have to do anything else, otherwise you can go to this page to receive your activation key: https://www.cisco.com/pcgi-bi...
The PIX only authenticates HTTP traffic if you tell it to authenticate it. All other traffic, including FTP and telnet will not be authenticated unless you configure it.
Since the PIX will not pass traffic out the interface it received it on, you need to enable split tunneling. Split tunneling is enabled by using the following command: vpdn group group_name split-tunnel access_list. The group name is your group name,...
Rajesh,The fixup protocol does many different things, such as allowing active FTP to go through the PIX. The SMTP fixup protocol, in addition to the banner stripping, only allows certain RFC 821 commands to go through the PIX. These commands are DATA...
Did you setup your nat and global?nat (inside) 1 0.0.0.0 0.0.0.0global (outside) 1 interfaceThis will allow all internal addresses to be pat'ed to the outside interfaces IP address.
