Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all!I have configured a LACP port-channel on my Cisco 4506 on one side and a Win 2k8R2 Fujitsu Server (Intel NIC) on the other. I have three interfaces on the server that join the etherchannel without any problems. Looking at the sh int po 9, I ge...
Hi all!I have an environment of two CUCM7.1 (sub+pub) at my main office and 8 remote locations, all with their own voice gateways. All voice traffic goes through the PSTN. One remote location complained last year about corrupted faxes. After moving t...
Karsten,thank you for your reply.I tried the default load balancing mehtod and have just tried to issue your command. Unfortunately, my 4506e (IP Base) does not offer to test any etherchannel related config.I have tried switching to a SRC & DST Port ...
Hi Kunal,thanks for your suggestion, but unfortunately the upgrade didn't help...CheersPhilEdit:Clicking around in the 'new' web interface, I found this:Should the dropped packet count concern me, or is this within boundaries of normal behavior?Cheer...
So, it seems I just had a bad case of not waiting long enough. I just created another QoS Detail Report from CAR and now the "Orig. QoS" field is filled. On every line, since yesterday 8.50 a.m. it says "Good"...So this should confirm my Cacti findin...
