Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have purchased a RV042 for a project and I am having an issue with the Dual Wan.I require to know can I have both ports running at the same time?Wan 1 Port = Internet port using static ip addressing provided by ISP.Wan 2 Port = Internet/DMZ por...
Hello everyone,I require some assistance with a Cisco 892. The router is running at the moment with the current setup.Gigabit Ethernet 0 port for the ethernet internet connection.Fast Ethernet 8 port for the internal lan.VPN tunnel configured for a ...
Hi Tom,If the ports do not operate simultaneously then I have got the wrong equipment and this was my fear, as since I require to provide static details for both ports then I hoped the RV042 would operate with both ports.I did also test with the por...
Hi Tom,I have a device (server) I require to connect to (10.10.10.13), which has a Cisco 2800 connected, I require to configure the Wan 2 port to have the following details (IP: 192.168.10.14, Subnet 255.255.255.248, GW: 192.168.10.13). I cannot cha...
Hi Abzal,I changed the port to half duplex as when I done a sh int fast0 it displayed half duplex 100Mbs and since I had a problem with the fast8 port and auto negotiation being set and it operated correctly when added duplex and speed manually.I hav...
Hi,The vlan1 is configured for Fast Ethernet port 0 and I have given the vlan the ip address of 192.168.11.14 and this port is connected to another cisco router which is managed by a third party and the ip address of the port used is 192.168.11.13 an...
Running ConfigBuilding configuration...Current configuration : 8526 bytes!! Last configuration change at 11:03:36 UTC Mon Nov 12 2012 by xxxxxxversion 15.2service timestamps debug datetime msecservice timestamps log datetime msecno service password-e...
