Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
We have and old DC with two Cisco WAAS's in WCCP GRE mode.This two are working fine, without any problem, see below configuration.
wccp router-list 8 10.111.12.129 10.111.12.131wccp tcp-promiscuous service-pair 61 62 mask src-ip-mask 0x1 dst...
Hi all,Is it posible to use one Cisco WAAS with dual inlineports connected to two PTT routers?Both PTT routers is active and load balacing with BGP wth local L3 switches.Or is it a most to use WCCP?Jan
Hi Finn,Thank you for the help.
This is what I will use for now.Please answer if you see any problem with it.wccp router-list 1 10.230.225.34 10.230.225.35wccp tcp-promiscuous service-pair 61 62 mask src-ip-mask 0x1 dst-ip-mask 0x0wccp tcp-promiscuou...
Hi Finn,
We have an 3850 switch on the lan side connected to the WAE.The below URL do not have this modell. Do you know what is support for WCCP and 3850?https://supportforums.cisco.com/document/133201/wccp-platform-support-overview#Introduction
I wa...
Hej Finn,Thank for the reply and yes we do have 4 ports inline card.BGP "TCP/179 is on the default policy as TFO with DRE Bidirectional and LZ and this what we normal use.Please explain more why we should pass-through the BGP.We haven't seen any prob...
Hi,Sorry but this does not answer my question, as I already know that it should be 9pin to 9 pin female.My question is what pin goes to what pin for tha cable?Jan
