Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an issue with the Mobility client...I download the installation image from the ASA from its public IP address and that goes fine. However, when I attempt to connect to the VPN, I indicate that same IP to connect to and the client responds that...
I am trying to make an internal host available to the outside, and for some reason am having some trouble doing so. Here's the relevant access list and NAT entry:
(inside1) to (outside1) source static NurseryInsp NurseryInsp_OUT
access-group outsi...
I have am ASA 5505 that I am trying to get running properly using the AnyConnect client. The issue is, that I can connect to the outside interface fine, but cannot ping or attach to any host on the inside. When I connect, it accepts the username and ...
I have an ASA 5510, and recently we had to move our web site to an external provider. However, portions of the web site still remain here on site. From outside, the web site operates fine, with the portions being hosted here as well as at the provide...
I have an ASA with 2 networks locally communicating with a remote PIX through a VPN connection. The ASA network 172.16.10.x is communicating through the tunnel to the PIX network 172.16.11.0 just fine as desired. The 2nd network on the ASA is 10.168...
The tunnel indicated by the outside1_cryptomap_10 lines on the ASA config. This tunnel works fine, except it will not pass traffic between the inside2 interface of the ASA and the PIX inside network.
Would the NAT solution also render any traffic from the inside1 interface to the 172.16.11.x network to reply to the inside2 interface? I still need the traffic from inside1 to continue normally to that 172.16.11.x network. There's a VPN connection ...
