Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Cisco Community,We currently have a DMVPN deployment where the IPv4 subnet assigned to the tunnel interfaces is approaching exhaustion. We need to increase the number of available tunnel IP addresses to support additional spokes. We are open to...
Hello Cisco Community,I am troubleshooting a fiber connection on a Cisco IR1101 equipped with an IRM-1100-4S8I expansion module.Router: Cisco IR1101-K9Router hardware revision: V10Expansion module: IRM-1100-4S8I, V01SFP: GLC-FE-100FX-RGD, V03SFP vend...
Thank you very much to both of you. The issue has been resolved. It was a hardware failure. We installed the IM module in another IR1101, and it worked on the first try.
Hi Mark,The remote device also do not have this feature (FEC)For me, the next and final test before considering this a bug is to connect the fiber optic link between Gi0/0/0 (the module in the main unit) and Gi0/0/5 (the port on the expansion module)...
Hi Mark,The remote device is an industrial RTU (Remote Terminal Unit) used for telecontrol and SCADA communications.The RTU has an Ethernet interface connected directly to the IR1101 through a point-to-point 100BASE-FX fiber link. There is no interme...
