Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,I hoping someone here can advise me. I have a network comprising Cisco 3500XL switch and two Cisco 2801 routers. I have a network with Cisco hardware and I am running a Motorola RF solution over it. The network is shown on the attached Vi...
I have a problem where clients cannot roam between Cisco 1231g-e-k9 and recently installed \cisco 1242g-e-k9 access points.. On looking at the CDP option on the 1231 and 1242 access points they are all aware of each other. However if I use the Netw...
Jon, I guess that so long as VLAN is same the ip subnet it's on will not matter. Trouble us it's that long since I did any of this, it's a bit if a brain teaser. Is there any chance you could do a quick schematic of how you would achieve the requir...
Jon, thanks for your quick responses. If I describe what I am trying to replicate can you suggest how best to achieve it.Have a head office site where a wireless switch (Motorola NX6500) is located. ( I am using rfs4000) in test config. There are ...
