Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm following behind a previous Engineer (we all know how frustrating that can be). I was given permission by the PM to reset the Firepower to Factory, which I did. I connected my laptop to the GE Management port (per the Configuration Guide), and...
Hey Marvin! So yes, I've opened a TAC Case....and it's strange because we have two Firepower 2010's, and one has the FTD Connect command available and one does not. So we just decided the best option is to re-image the "problem appliance". Thanks...
https://ciscoskills.net/2017/12/01/factory-reset-firepower-2100/ You are correct! Per the Cisco Guide, I "should" be able to access the Web Interface via the 192.168.45.45ProcedureStep 1On your management computer connected to the Management 1/1 in...
The CTRL-A then D, isn't workingWhen I log on I get the FIREPOWER# prompt. Not sure if I need to be at the FIREPOWER> prompt for the 'Connect FTD' Command to work. I did use the "up" command to try to go up in the hierarchy, but that didn't work e...
The CTRL-A then D, isn't workingWhen I log on I get the FIREPOWER# prompt. Not sure if I need to be at the FIREPOWER> prompt for the 'Connect FTD' Command to work. I did use the "up" command to try to go up in the hierarchy, but that didn't work e...
Thank you Marvin for your Reply!!! I actually found that command in the Firepower Quick Start Manual, but apparently the command isn't available on my appliance??? (see below) firepower#firepower# connet ftd ^% Invalid ...