Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 4507R that will be using track and sla for failover/failback on two WAN circuits going out of my switch. Is there a way to configure an email notification, or some other sort of notification to let me know which route is being used, especial...
I am working on a new failover strategy for my remote sites that will utlize diverse carriers on both my HQ side and remote sites. I currently have two Firewall/UTM devices that service different internet connctions directly to my core layer 3 switch...
I need to run trunking btween my core L3 switch (4507R) and a switch at my co-location (3560). When attemping to configure both sides as a trunk, the line never came up on the 3560. The biggest thing that stood out was that I could not set the speed ...
I finally got this to work. I simply needed to add a static route for my target IP to always use the primary route next hop IP address. My final config is as follows...track 1 ip sla 801ip route 10.1.0.0 255.255.255.0 10.62.0.2 track 1ip route 10.1.0...
I made a few changes to my track and sla statements. Do these look right or do I need to change anything?track 1 ip sla 801 reachabilityip sla 801icmp-echo 10.1.0.4timeout 300frequency 3ip sla schedule 801 life forever start-time nowsh track 1Track 1...
