Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My Cisco ASA is the default gateway, so for comunicating with each other Servers in different vlans use ASA...and i need to open these ports for some application ...
Here is what i need.Servers at Vlan 6 must see servers at Vlan 2, 10, 11, 12. and and vica versaHow to write the correct commands.Here is my outputs:VLAN Name Status Ports---- ------------------------...
Here is what i need.Servers at Vlan 6 must see servers at Vlan 2, 10, 11, 12. and and vica versaHow to write the correct commands.Here is my outputs:VLAN Name Status Ports---- ------------------------...
Mohit, i've solved the problem.The routing between vlans were on my ASA. And ACL's vere there two... the problem was in acl's they were extended and for spoecific protocols. i've changed it to standard specifying Ip's and everything started to work.....
Strange output:(((phfwasa01(config)# route inside 172.16.30.0 255.255.255.0 172.16.0.1phfwasa01(config)# sh route Gateway of last resort is gw_int to network 0.0.0.0S 192.168.10.0 255.255.255.0 [1/0] via 192...
phfwasa01# sh routeGateway of last resort is gw_int to network 0.0.0.0S 192.168.10.0 255.255.255.0 [1/0] via 192.168.0.1, insideS 172.16.29.0 255.255.255.0 [1/0] via 192.168.0.1, insideS 172.16.30.0 255.255.255.0 [1/0] via 192.168.0.1, insid...
Hi, Varun, thanks for your quick response.Yes i'm trying to open ports for traffic between different lans on the firewall.I have DMZ vlans ans Server vlans, beside both of them i have one more Vlan with UPS's using network shutdown module.it uses por...
