Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I didn't find an answer to my question in this forum, even if some persons have spoken about this subject.I am running with a current Active/Standby configuration of two ASA 5520 with version 8.2(5).I want to reverse their configuration as th...
Hi all, I'm configuring a setup in which one two 1921 routers are connected together by two differents paths: one through Internet, the other one through an MPLS.Each router has its own LAN connected on it and the aim of this setup is that the commun...
Hi Everybody,We would like to implement a solution on a remote site where there is a MPLS connection and a Internet connection. In fact, we have a permanent VPN tunnel between this site and a central site. We would like to install a Cisco router whic...
Hi everybody,We currently have a Nexus 5010 where some of our customers are connected. There is also a SAN server where all customers can connect to.Currently, all servers of all customers have a dedicated interface plugged into the Nexus 5010 in the...
Great, thank you very much ! I'll proceed with the failover active so.Therefore, there is no way to change the command "failover lan unit primary/secondary" to have a proper configuration ?
Hi, Thank you for your reply.In fact, to make it simple, I want to reverse the current Active/Standby cluster. I know that the command "failover active" will force the failover, but I assume it's not a good situation ? If ASA 1 is the current active ...
Hi Nagendra,Thank you for your reply.I'll continue the configuration in this direction so and I'll use the distance metric to be sure that the priority is well interpreted by the routing protocol.Thank you very much. Best regards,Damien
Hello,OK, thank you for this information.Yes I've understood the routing but in my tool NetSim from Boson, I can't test it due to wrong version of IOS as explained earlier in this discussion.I've tried with GNS but I don't have the IOS yet and I'm no...
