Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a situation where I have just been provisioned a new T1 line from At&t. They refuse to do multilink ppp on the 1841 router they sent me, and I have another T1 already in place with a managed 1700 series router, again, they refuse to do multil...
This may be in the wrong forum, but I have a small issue:I have an ASA 5510 that has two directly connected networks that I need to talk t oeach other. One is 10.25.240.x and one is 172.16.10.x. the 10.25.240.x is on the inside interface of the ASA...
Is there any way to use an asa 5510 to detect which computer on the inside of my network is connecting to ip 87.255.51.229. I am being blacklisted for w win32/Zbot connection, I need to identify this computer and get it disconnected from the network...
I have a 5510 with an SSM-10 Card installed in it.Router has a public IP on the outsideRouter has 10.25.240.3 on the insideASA FA0/0 has 10.25.240.1 as the outside interface which is the gateway address for my entire network, as I had a sidewinder f...
After reading a reply from Jon Marshall, I scrapped the router and put all of my L3 Sub interfaces on the ASA, hooked it up to a trunk port on my switch and all of my VLANs came up. I can ping from the host thru the switch to the vlan gateway on the...
Network is pretty simple. T1 into an ASA 5510, out to a 3750 Switch , out to some 2950 switches. Pretty flat actually, everything ting is on the same ip range 172.x.x.x, dhcp hands out the client addresses. Using NAT thru the ASA to 1 public IP a...
Maybe I am using the wrong terms here. Everything works on the inside of the ASA, all Networks talk to where they are suppose to. I plug a cable into Fa0/1 all of my vlans come up and I can ping, scp, ssh, all that good stuff across all of the vla...
Here is a visio and a PNG file, This is the proposed end state that I need to obtain. All of the L3 Routing and DMZ stuff works on the inside, I just can't figure out how to get it to the outside. I have probally just looked at it too much and ca...
Now I am more confused....4 ports on the ASAFa0/0 10.25.240.1 with a static route to 10.25.240.3 (Router inside IP)Fa0/1 no IPfa0/1.1 10.0.10.1 vlan 801fa0/1.2 10.0.20.1 vlan 802fa0/1.3 192.168.255.1 vlan 803fa0/1.4 10.25.241.1 vlan 804fa0/2 10.26.24...
