About davegibelli

davegibelli · 07-25-2018

In Cisco IOS XE Software version 16.06.03 running on a 3850 with ipservices k9 the command ip tcp adjust-mss is missing. Does anyone know how we get the same behavior that we used to have?

davegibelli · 10-12-2017

I have created two AP groups but I am only seeing the first SSID being broadcast in each group even though there are two SSID's in group 1 and three in group 2. It is a 2504 WLC running 8.2.151.0 and the AP's are 3702, any ideas?

davegibelli · 02-04-2016

Hi I have a pair of ASA5520's running 8.4(7) with the standby logging "NAT/PAT pool exhausted. Unable to create connection", the active ASA does not log the same message. I don't understand why the standby is logging anything, is this a bug?

davegibelli · 06-27-2015

This article describes LED patternshttp://www.cisco.com/c/en/us/td/docs/wireless/access_point/3700/quick/guide/ap3700getstart.html#60734except it does NOT mention the pattern I have, I do hate it when documentation is not accurate.I have Red-Green-Of...

davegibelli · 05-30-2015

I have two WS-C3750X-48 connected together with both the ports set to auto,however, the ports are running at 100M/full. Cisco even recommend auto-neg but why is it only running at 100M?I have two pairs with the same issue, this is very strange.Softwa...

davegibelli · 10-21-2017

The SSID were broadcast as expected, I was given incorrect information from management! So never trust the information you are given.

davegibelli · 06-30-2016

Hi I have just gone back to this issue as it is still there, see below, there are nowhere near 65,000 connection: Jun 30 2016 15:59:37: %ASA-3-202010: NAT/PAT pool exhausted. Unable to create connection. Jun 30 2016 15:59:37: %ASA-3-210007: LU alloca...

davegibelli · 06-01-2015

Using the "test cable tdr" commands show the cable as normal for all pairs!I am not physically near the switches but this is very weird as there are four switches connected in a ring. The ports set to trunk are running at 1000/F but the access ports ...

davegibelli · 02-09-2015

JonYour suggestion will not work, here is the explanation and it is crazy!I solved it, this might be useful for others. The 6509 behaves differently from a 3750 when assigning MAC addresses to interfaces. The 3750 uses the MAC address assigned to the...

davegibelli · 02-07-2015

JonI remove etherchannel and used L3 interfaces but still no ping. The 3750 works with etherchannel or L3 interfaces. But there is a difference.The 3750 has a different MAC address per interface but the 6509 uses the same MAC per interface.6509#sh ar...

Member Since	‎07-16-2006 08:32 AM
Date Last Visited	‎03-06-2022 12:47 AM
Posts	78
Total Helpful Votes Received	5

User Statistics

User Activity

ip tcp adjust-mss command missing

SSID missing after introducing AP Groups

Very wierd, NAT/PAT pool exhausted but only on standby firewall!

AP C3702 LED sequence

Gigabit link is auto neg to 100M

Re: SSID missing after introducing AP Groups

Hi

Using the "test cable tdr"

JonYour suggestion will not

JonI remove etherchannel and