Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to determine which interface module I need to provide a ethernet interface to the 1841. I have a fractional T1 in the one interface, but want to bring in a second network segment from one of my switches. Can someone point me to the corre...
Not sure if this is the right forum but we will try. I have two separate closed networks, both with an ip range of 192.168.1.xxx, with a large number of devices in each net so that I cannot combine them into one. We shall call them NetA and NetB.I ha...
Good Morning. I've got a question on how to combine subnets. I have 3 small closed networks, all utilzing a ip range of 192.168.1.xxx These networks have no "outside" connectivity to the world and are located in 3 seperate physical locations. To allo...
Good Morning.I've got a question on how to combine subnets. I have 3 small closed networks, all utilzing a ip range of 192.168.1.xxxThese networks have no "outside" connectivity to the world and are located in 3 seperate physical locations. To allow ...
I have been unable to verify if the 1841 will support 2 HWIC cards at once. I know that it has two slots, but, can it handle 2 HWICs for input at once?
No. I have 3 distinct, geographiclly seprated closed networks, Each network was built with 192.168.1.XXX subnet. When originally designed, the 3 networks were to never connect to anything.However, I now need to manage these networks remotely. Thus, I...
