Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What are best practices in consideration to wireless network design? I have a WLC 4400 and 1200 AP's that I want to deploy to replace my existing wireless network. I am researching the best network design for implementing a secured wireless infrastru...
I have a 4400 LAN controller where the ap-manager port is on the same subnet and VLAN as the management port but I cannot ping the ap-manager IP nor will the LWAP associate to it. What could be my problem?
I have a remote site that connects to our corporate network through a site-to-site vpn connection. I can access all networks from the remote site to the corporate site with no issues. However I cannot access the Internet from the remote site. Our Int...
HELP - PLEASEI cannot access any internal websites but can access external sites. Has anyone seen this type of problem before. Routing is correct and dns is resolving but no connection to internal websites. If you've seen before this please help.
I have a question that concerns UDP packet flow over a 12 port switch. When a UDP packet is sent to a IP destination will the UDP packet flow over every port on a switch? When I sniff each port these packets are flowing over ever port. Is this normal...
I entered the nat (Internet) 10.2.18.0 255.255.255.0 statement and it didn't work to begin with but after a few minutes it started working. I will confirm again by making sure that all NAT overload configuration is removed from the remote router and ...
The whole config would take very many pages. I am including the specific config that is for the remote network as it is now without any new changes you suggested. I hope this will shed some light on my config for the remote site.global (Internet) 1 x...
Just to clarify, if this is my current network.global (Internet) 2 netmask 255.255.255.192 <-- PAT Interface nat (Inside) 2 10.2.18.0 255.255.255.0 <-- remote network ip rangeThen your config change should be?no nat (Inside) 2 10.2.18.0 255.255.255....
I added all configurations as suggested but no work for me. How can I troubleshoot. Please HELP!!!global (Internet) 2 x.x.x.20 netmask 255.255.255.192 <-- PAT Interfacenat (Inside) 2 x.x.x.x 255.255.255.0 <-- remote network ip rangeI have all ACL's w...
