Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup a stack using MS-350 switches. I have followed the instructions and have other stacks working. Though for some reason only the main switch will connect, the others show offline. I have tried a 3 stack setup and just switched to a...
I am trying to add a new IP range to my voice VLAN. I have it to where it works on the local network, but when the system makes a call outside I can here the person but they can't hear me. I am not sure where to check to see what the problem is. I se...
I am having an issue where when a user trys to pickup a line on the phone it hangs for a bit then the call is answered. Also when a call is transfered to another line the same thing happens to the person doing the transfer. It doesn't happen all the ...
Why do I get this error message on one of my switches? When it happens it knocks the port out anywhere from a few minutes to a few hours. Here is the config for the port: switchport access vlan 50 switchport trunk encapsulation dot1q switchport trunk...
I have been trying to setup my ASA to block P2P traffic. I followed the guide here http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00808c38a6.shtml. When I make this my config I lose all HTTP traffic. I also tried to up...
If I give it the same Gateway IP as the orginal range it won't register. If I give it the first IP in the new range it registers and works locally. Sometimes the simple things are the most overlooked. Mark
I found that and would accept it, but when I get this error the port is shuts down and either comes back up quickly or will stay down until I either do a shut no shut or unplug and replug the device back in.
