Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a routing problem from a new subnet and vlan I have setup. The network setup is as follows:4006 layer 2 and 3 switch serving vlan 1 on LAN behind PIX. On this side of PIX we also have networks across WAN. On other side of PIX we have vpn ...
Hii'm just converting my ACLs to use object-groups and just wanted ti check the ACLs I have written are OK. To start with I have some ACLs of:access-list example permit ip 192.x.x.0 255.255.255.0 10.x.0.0 255.255.0.0access-list example permit ip 192...
we have a 4006 with a supervisor 3 engine, 2 fibre modules and one gigbait ethernet module and the rest with standard 10/100 modules. This unit recently went pop and we had it replaced under our existing smartnet agreement. I have now been tasked wi...
good- sort of as that had been confusing me too! this config is something I have inherited and I'm just coming to terms with (and the counters have been cleared recently). I've bene taske dwith cleaning up a config which has had numerous people wor...
yup sureaccess-list 1 permit ip object-group UK_Network object-group Canada_Networkaccess-list 2 permit ip object-group UK_Network object-group Canada_Networkboth getting hit- why are both needed- wouldn't just one do the job?
