Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does the 2566-P4W-R come with a mounting bracket as depicted in the attached image? I can't seem to find what all comes with the antenna or if Cisco makes a mount kit for it.
Does anyone know how to join -b regulatory domain access points to a controller properly? I have a 2504 running 8.2.121.0, a known firmware release that supports -b access points. I cannot get the AP's to download the firmware and register properly. ...
Does anyone have recommendations for Cisco Prime training? We are implementing this on a wireless solution and we are looking for some training for it.
I am currently setting up a L2L tunnel, I need all traffic from my site to get translated to an address before it traverses the tunnel. All VPN traffic from my site will be coming only from one device.Traffic internally will be coming from 192.168.0...
I set up active/standby failover between two ASA 5510s and something keeps causing this to failover approx once a week. When the it fails over it loses the vpn connections instead of handing them off. It is currently running version 7.2(2) on both....
I have attached the debug. We are specifically looking at the 2 access points that are 10.0.20.101 and 10.0.20.102. I have a primary and secondary controller, running the same config and code.
