Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have an ASA series appliance (8.2 I believe), and I am trying to get active directory to work across this appliance in routed mode. - I have a workstation that is on the outside (192.168.70.151 subnet) and 2 redundant active directory contro...
Background:- Small isolated network (no internet access)- No DHCP server running, all IP addresses are static- TFTP server is running at 192.168.4.101- Have switch IP configuration (vlan1) set to 192.168.4.200, subnet mask 255.255.255.0- Cannot succe...
So I was able to set up the NAT in this way, and all traffic appears to be flowing through the firewall, but the workstation is still not registering with the domain. After much research on Microsoft's website, it turns out that I will not be able t...
Hello Jennifer, thank you for your reply!1) I am NATing the AD servers to the same subnet as the outside interface (192.168.70.101 and .70.102)2) Yes, the outside interface is 192.168.70.2103) The PC's default gateway is the outside firewall interfac...
Rick,The switch is running successfully, but does not include the cryptographic software image that I need to enable SSH. I have downloaded the image from the Cisco support site, and have the .bin in the TFTP repository on the server. No other swi...
