Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone!
Our IT person is out of the country on vacation and we have a serious problem. We need to add a new /29 IP WAN block to our network as we need more servers to get assigned public IPs. Currently, we have one /29 assigned to our IG0/0 int...
I have a LAN with 6 vlans and a 2821 router. By default, intervlan routing is enabled for all vlans, however, I want specific vlans to be denied access to others, though all should still be able to use the Internet being served from GE/0. Sent from C...
I have setup nat on three sub interfaces but when trying to browse to local servers, such as our web server, that have been translate, we get a prompt to logon to the router. I suspect these internal addresses should not be natted for local users. Se...
Yes its an Ethernet circuit, so they have blocks of IPs delivered to us over a single VLAN which going to their switch in the building. Then a port with a fiber cable running to our office is untagged with our vlan. So lets say our vlan is 2002 - the...
Yes i'm referring to the default gateways of the first block of 5 .194 - .198. Those are all using the .193 default gateway as indicated in the ip route 0.0.0.0 0.0.0.0 x.x.158.194 statement.
What I thought I had to do was simply add the second ip ro...
Hi All,
First off, thank you so much for trying to help me with this in my time of crisis.
The issue is one of default gateways. Even if i remove the secondary, i still can't use the public IPs because the router has no knowledge of them.
And with...
I thought something like that. The sanitized output is below. I replaced sensitive IPs and other stuff but you have the whole configuration there. As you can see, we use all the IPs for the multiple port forwards we have for different servers, our PB...
