Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllWhat causes high latency on the 2950? I have the following configuration:Building A Building B 3750------------------2950dashed line = wireless link between building A and building BI have setup trunk between the two switches. Whe...
How do I bias an etherchannel?I have one group of etherchannels(2links).1st link = 100Mbit/s2nd link = 20Mbit/sHow do I make all the traffic go over the faster first link and then only over the 2nd link if the 1st link fails? Is it possible to make...
It is an etherchannel between a layer 3 switch 3750 and a layer 2 2950 switch. The etherchannel is layer 2 though.Please tell me more about PBR (Policy Based Routing) and am I able to do it with the 3750 switch.Thanks
Can you suggest a better way then please ?my primary link is a laser(100Mbit/s)backup link wireless radio link (20Mbit/s)Layer3(3750)------------Laser--------Layer2(2950) ------------Radio--------What is the best way of making these link r...
you are not listening. I have configured the etherchannels with the different link speeds and it works. No PROBLEMS.I need to know how to send the majority of the traffic over the faster link?If you think this is a bad way of doing combining two link...
I have created the etherchannels and they work perfectly. Traffic goes over both links simultaneously and if one link fails then all the traffic goes over the link that is still up.Is there a better way of doing this with 2 links that are different ...
